Beko TBN7606W Manual Del Usuario página 8

3 Operation
A
WARNING: Never let the jug
blender operate while empty
(without food).
A
WARNING: Never let the jug
blender operate without the jug on
the motor housing.
6. Close the lid (3). Make sure that the cap/
measuring cup (1) is inside the lid opening and
is secured.
7. Place the jug (4) upright onto the motor housing
(8).
A
WARNING: Never move or turn
the jug after it is properly seated in
the place.
8. Connect the power plug to a suitable power
outlet.
9. The cutting speed can be variably adjusted with
the control dial (9).
C
To operate the blender at the low
speed, turn the control dial (9) to "1".
C
If you want to blend with a higher
speed, turn the control dial (9) to the
desired speed level (2-3).
For short pulses of blending with a
C
high speed, turn the control dial (9)
to "P". When you release the control
dial (9), the blender will stop and
return to "0" automatically.
If ingredients are to be added during
C
the blending process, then add them
through the opening in the lid (2). To
do this, take out the cap/measuring
cup (1).
10. After the desired consistency of the blended
food has been reached, turn the control dial
(9) to 0 to switch off the blender
8 / EN
A
WARNING: Never run the blender
for longer than 1 minute, otherwise
it would overheat.
A
WARNING: After running the
appliance for 1 minute, let it cool
down before using it again.
WARNING: Be sure the motor
A
is switched off and has completely
stopped before removing the jug (4)
from the motor housing (8).
A
WARNING: Do not place any
utensil (scraper, fork, etc.) in the jug
while blender is operating.
11. Pull the power plug out of the power outlet.
12. To remove the reservoir (4) from the motor
unit (8), rotate it anti-clockwise and lift it, and
then remove the measuring beaker (1).
13. Take off the lid and pour the mixture into
glasses or other containers.
3.3 Fruit Filter
The fruit filter is for fresh fruit juices and cocktails.
It prevents pips and skins from your drink.
1. Fit the filter into the middle of the jug.
2. Cut the fruit into small pieces and put it in the
fruit filter.
3. Close the lid of the jug by turning it clockwise.
Make sure that the cap/ measuring cup is inside
the lid opening and is secured.
4. Connect the power plug to a suitable power
outlet.
– The cutting speed can be variably adjusted
with the control dial.
5. After the desired consistency of the blended
fruit has been reached, turn the control dial to
0 to switch off the blender.
Table Blender / User Manual