Statement 383-Grounding Requirement, Green And Yellow 6 Awg Ground Wire; Statement 1003-Dc Power Disconnection; Statement 1004-Installation Instructions; Statement 1005-Circuit Breaker - Cisco ASR 920 Serie Manual Del Usuario

Statement 383—Grounding Requirement, Green and Yellow 6
AWG Ground Wire
This equipment needs to be grounded. Use a green and yellow 6 AWG ground wire to connect the host to earth
Warning
ground during normal use.
Statement 1003—DC Power Disconnection
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1004—Installation Instructions
Warning Read the installation instructions before connecting the system to the power source.
Statement applies to: Ethernet, USB, and PoE
Statement 1005—Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective
Warning
device is rated not greater than:
15A for DC system. For AC system: 15A for voltages greater than 200Vac; 20A for voltages below 127Vac.
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
6
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
OL-32476-01 Rev. V4