Motion Freestyle Scooter Manual De Instrucciones página 4

Keep the instructions for future.
NF-EN-14619
READ THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER BEFORE
USING. MAXIMUM WEIGHT: 100 KG
Warnings
- The Scooter is suitable for adolescents and adults. It is not a toy, but sports
equipment for physical training.
- Use with caution on a clean, dry surface and, if possible, away from other
users, and obey the road safety rules.
- Check local laws regarding scooter use, respect all the
Stay away from other pedestrians or users on public roads.
- Best when used on a dry surface free of gravel and grease. Avoid bumps and
drainage grates that might cause an accident.
- Warning! Protective equipment consisting of wrist protectors, gloves, knee pads,
helmets and elbow pads should be worn.
Using the scooter
• Before and after each use:
- Check the height of the steering system and make sure that the nuts are
tightened and the handlebars and front wheel are perpendicular.
- Check all of the connection elements: the brake, the release system of the
steering column and the wheel axles must be correctly adjusted and must not
be damaged.
- Also check the tire wear.
• Braking:
- A brake is located at the rear, when necessary, press down on it to slow down.
Press down gradually to prevent skidding or loss of stability. The metal brake may
heat up after multiple uses. Avoid touching it during and after use.
4
During use:
- Standing on the scooter, with one hand on each handle, push with one of your
feet to move forward. Proceed with caution at the start.
- Always wear shoes and we strongly recommend wearing pants and long sleeve
shirts to avoid injury if you fall.
- The scooter does not include any headlights or lights. It is therefore not suitable
for use at night or during periods when visibility is limited.
- Do not use on wet days, or on wet ground.
rules and signs.
Assembling the product (See page 2)
1. Loosen the screws of the clamp with the allen key provided.
2. Insert the handlebar into the stem of the fork while paying attention to the
position of the base.
3. Position the clamp with the screws on the back side of the tube.
4. Tighten the screws of the clamp with the allen key provided.
5. The tightening of the screws should be progressive and successive
(between 5 to 10 times), so as not to damage the screws and the clamp,
until they are locked in place.
6. Those who do not have enough strength to tighten the screws with the allen key
provided might
After each use make sure that the screws are tightly in place so that the handlebar
doesn't detach itself.
DO NOT FORGET TO REGULARLY TIGHTEN ALL BOLTS AND SCREWS TO
AVOID MISALIGNMENT OR LOSS OF THE SCREW.
that using a different tool may be easier.