Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURE 2
6
6
15
Step 2:
Fasten the center connector with ring (#3) to the
middle of the legs (#2) by using bolts (#6). Keep the
bolts loose. See Figure 2.
FIGURE 4
A
Step 4:
Turn the table to its upright position. Place the tiles (#5) onto the table top (#1).
leveler on the legs (#2) as needed. See Figure 4 and Figure 5.
Note:
1) If any EVA foams on the table top (#1) are missing, there are extra EVA foams in the hardware kit.
See Illustration A.
2) To use an umbrella with this table, remove the plastic center plug and put the umbrella pole through the table
top and center connector ring.
Cleaning and Maintenance
• Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach,
acid, or other solvents on the frame parts.
• Inspect and tighten all of the bolts and fasteners on a regular basis to ensure the proper
performance and safety of your table.
• When moving the table, remove the umbrella and lift. Do not drag this table.
• We recommend the use of furniture covers when not in use.
• In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and
protected area during off season periods.
• The umbrella should be lowered and/or removed in windy conditions.
V-3
2
2
2
3
#6 BOLT M6*15
5
1
STOP
DO NOT RETURN TO THE STORE!
FIGURE 3
2
2
4
Step 3:
Fasten the center connector (#4) to the middle of the
legs (#2) by using bolts (#6). Make sure that all of the
bolts have been tightened completely. See Figure 3.
FIGURE 5
2
PAGE 2 OF 3
2
2
2
15
#6 BOLT M6*15
2
2
2
You can adjust the
6
2
Publicidad
