GLOBBER ONE K 125 Manual Del Propietário página 8

3 - Folding the scooter
• Before folding the scooter, set the T-bar to the lowest
position and make sure the spring-loaded button snaps
securely in place.
• Both hands on the handlebars, giving a slight kick pedal
lock as shown in the drawing 4. Fold back the T-bar handle
until it locks on the back brake with an audible click, as
shown in the drawing 5.
• You can grip the scooter by the T-bar handle and pull it
behind you for easy transport.
• For storage purposes, remove both parts of the T-bar
handle from the T-bar.
• Open the clamp lever on the top of the handlebars, press
down the spring-loaded buttons located on the top of the
handlebars while pulling out the handlebars' grip sideways
at the same time. Strings inside the tubes will hold the
individual handlebars' grip together. Clip both grips of the
T-bar handle into the clips on both sides of the steering bar.
DO NOT FORGET TO REGULARLY TIGHTEN THE
DIRECTION BLOCKS TO AVOID MISALIGNMENT OR
LOSS OF THE SCREW.
8
Care / Maintenance: regular maintenance is a safety
commitment;
- Wheel bearings: avoid going through water, oil or sand
as this can damage wheel bearings. To look after the
wheel bearings, systematically check that the wheels turn
properly by turning the scooter upside-down and using
your hand to spin the wheels. If the wheels do not spin they
must be removed to check their condition. First unscrew
the wheel axle, remove the axle and detach the wheel,
then carefully push the two wheel bearings out of their
housing. If they are chipped or dented, new ones should
be bought. If there is no visible damage, they must then be
oiled. To do this, remove all traces of grease, mud or dust
with a kitchen towel or cloth, and re-oil them with a grease
spray or by leaving them to soak overnight in oil [turn
them several times in the oil first]. Then reassemble the
wheel bearings and axles, followed by the wheel, onto the
scooter. Proceed in the same manner for the other wheel.
- Wheels: the wheels wear down with time if overly used
on rough surfaces. In the interest of safety, they should be
checked regularly and replaced if necessary.
- Modifications: the original product must by no means
be modified except for the maintenance-related changes
mentioned in these instructions.
- Nuts, axles and other self-locking fixings: these should
also be checked regularly. They can become loose after
a while in which case they should be tightened. They can
become worn and not tighten properly, in which case they
should be replaced.