Eco Function; Filling The Boiler When Hot; Pressure Gauge; After Use - Imetec IRON MAX ECO 2400 Instrucciones Para El Uso

ECO FUNCTION

The appliance is equipped with new technology able to optimise steam production and
consequently, reduce energy consumption. This functon is always active.
Press the Extra Steam button (6) to activate the ironing program for the most difficult clothes.
It is advisable to use the Extra Steam function for ironing resistant items (jeans, cotton and
linen).
WARNING!
Never unscrew the boiler safety cap (1) during normal ironing operations.

FILLING ThE BOILER WhEN hOT

When there is no more water inside the boiler, the iron stops producing steam and the no
water indicator light (3) turns on:
• turn off the iron/boiler on/off button (7);
• disconnect the plug (8) from the socket, wait a few minutes and loosen the safety cap (1)
slowly to release any remaining steam in the boiler;
• unscrew the safety cap (1) completely and wait a few minutes before filling up the tank;
• fill the boiler very slowly with water using the provided funnel (13), being careful not to
overfill. The boiler has a capacity of approx. 1 litre;
• at the end of the operation, screw on the safety cap (1) tightly;
• Start ironing again, following the instructions in the "IRONING" paragraph.
WARNING!
The temperature inside the boiler is very high. When cold water is added
it immediately vaporises and steam is let off. So pay the utmost attention
when filling up.
PRESSURE GAUGE (where present)
The pressure gauge (2) keeps the steam pressure level in the boiler under control. While you
are ironing, the pointer will move according to the demand for steam and will position itself in
the area between yellow and green.

AFTER USE

• Turn off the iron/boiler on/off button (7);
• then disconnect the plug (8) from the socket;
• wait for the appliance to cool down before putting it away.

MAINTENANCE

CLEANING ThE APPLIANCE

Switch off the appliance and disconnect the plug (8) from the socket before you clean it.
Clean the appliance with a damp cloth when necessary. Never use solvents or other harsh
abrasives or cleaners. These substances may damage the surfaces.
Before re-using the appliance, make sure that any parts you have cleaned are completely dry!
GB
13