Imetec IRON MAX ECO 2400 Instrucciones Para El Uso página 20

Problem
Impurities come out of
the iron's soleplate.
Drops of water come
out of the soleplate.
The appliance does
not produce steam.
The soleplate is dirty.
While ironing, steam
comes out of the boiler
safety cap (1).
Areas on fabrics stay
wet during ironing.
I cannot rest the iron in
the vertical position.
Possible causes
This is completely normal for
a new iron.
The steam regulation knob
(12) has been set at too low a
temperature for steam ironing.
The appliance is not
switched on.
You are not pressing the
steam push-button.
The water in the boiler
is finished and the water
indicator light (3) is on.
The steam control knob
(12) is set on the minimum
temperature.
The impurities and chemical
substances in water have
deposited on the soleplate.
The temperature you are
using for ironing is too high.
The boiler safety cap (1)
might not be properly closed
or perhaps some water
spilled out while filling.
Sometimes wet areas
appear on fabrics after
ironing because steam has
condensed on the ironing
board. Iron over the wet areas
several times to dry them
without emitting steam. If the
lower part of the ironing board
is wet, dry it with a dry cloth.
The iron was designed only
for horizontal use.
Solution
These particles are completely
harmless and will disappear
after the iron has been used a
few times.
Set the right temperature for
steam ironing (see "IRONING"
chapter).
Press the iron/boiler on/off
switch (7).
Press the steam release
push-button (11) when steam
ironing.
Fill the boiler (see "Filling the
boiler when hot" chapter).
Set the steam control knob (12)
(see IRONING chapter)
Wait that the soleplate has
cooled down and clean it with
a damp cloth.
Wait that the soleplate has
cooled down and clean it with
a damp cloth.
Turn off the appliance and let it
cool. Remove the boiler safety
cap (1), dry the water around
the filling opening and put the
cap back on. Now you can
switch the appliance on again.
Use an ironing board with a
mesh cover to prevent steam
from condensing on it.
Place the iron on the heat-
resistant iron support mat.
GB
15