Worx WG205E Traducción De Las Instrucciones Originales página 12

SYMBOLS
To reduce the risk of injury, user
must read instruction manual.
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Do not expose to moisture
Remove plug from the mains
12 12
immediately if the cable is
damaged or cut.
Double insulation
Keep hands away
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
Hedge trimmer
OPERATING INSTRUCTIONS
WARNING! Do not use the product
without fitting the guard.
INTENDED USE
The machine is intended for cutting and
trimming hedges and bushes in domestic use.
1. ASSEMbLY OF THE GUARD (See Fig. A)
Insert the guard into the slot as illustrated in
Fig. A, and use two screws to fix the guard
securely.
2. FITTING THE SHOVEL (See Fig. b- c)
(WG208E)
Place the shovel until into place, tighten the
screws.
You can fit the shovel on both sides. (Left hand
or Right hand)
3. MAINS SUPPLY cAbLE STRAIN
RELIEF (See Fig. D)
For strain relief of the cable, form a loop of
the end of the extension cable and bring
this through the opening at the handle and
suspend in the tension relief at the handle.
4. STARTING AND STOPPING (See Fig. E)
bEFORE STARTING YOUR HEDGE
TRIMMER
Remove blade sheath (7) as illustrated in Fig F .
TO START YOUR HEDGE TRIMMER
There are two switch levers fitted in your
Hedge trimmer (2&4).
Both switch levers need to be depressed for
the product to start. Depress and hold the
front switch lever (4) and press the switch
lever (2).
TO STOP YOUR HEDGE TRIMMER
Move Hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers.
WARNING: If any parts are missing,
damaged or broken, do not operate your
Hedge trimmer until all damaged parts have
been replaced or repaired. Failure to do so
could result in serious personal injury.
EN