Publicidad
Anti tip kit 2x
Nylon Strap 2x
Mounting Plate 4x
NOTICE: To prevent injury and property damage from unexpected tipping
of furniture, we highly recommend installation of the anti-tip kit
and mending plates included with this product.
Mending plates must be used to attach armoie to base cabinet.
1. Align mending plates (E) over the top nack edge of the base cabinet and the bottom back edge of the armoire about 2 inches in
from the sides. Insert screws (D). Do not overtighten!
Attaching furniture to wall with anti-tip kits.
1. Determine where the piece is to be placed and mark location on the wall for the mounting bracket
screw holes. They should be placed approximately 1" below the top on the back of the piece of furniture.
2. Attach the mounting bracket vertically to the wall by inserting the long screws provided through the
holes in the bracket and tightening securely using screwdriver. Screws must penetrate wall studs for
proper installation.
3. Next using the short screws attach the 2nd bracket to the back of the piece of furniture's top.
4. Lace the nylon strap down through the brackets. Slide the thin end of the strap through the
receiving end of the nylon strap. Pull to tighten the piece of furniture snug against wall.
CARE INSTRUCTIONS
Hardware may loosen over time. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
Small Screw 4x Large Screw 4x
Publicidad
