Troubleshooting - Primo Water 900139 Manual De Usuario

TROUBLESHOOTING

Dispenser does not operate.
• Make sure the power cord is properly connected to a working outlet.
Water is leaking.
• Bottle may have a leak. Remove bottle and replace with new bottle.
• If leak remains, remove bottle and call 866-429-7566 for assistance.
No water is coming from the taps.
• Make sure the bottle is not empty. If so replace it.
• Make sure to push the water controls in fully.
Cold water is not cold.
• It takes up to one hour after setup to dispense cold water.
• Make sure the back of the dispenser is at least 4 inches from a wall and there is
free airflow on all 4 sides of the dispenser.
• Make sure tank is not overfilled due to a bottle leak. Dispense water until bubbles
appear in bottle.
Hot water is not hot.
• It takes 15-20 minutes after setup to dispense hot water.
• Make sure the power cord is properly connected to a working outlet.
• Make sure energy saving switch is ON.
Dispenser is noisy.
• Make sure dispenser is positioned on a level surface.
Water tastes bad.
• Drain water from reservoirs and replace bottle with a fresh one.
• Clean dispenser per Proper Care & Cleaning instructions.
Nightlight Isn't Working
Make sure the power cord is properly connected to a working outlet.
•
• Bulb could be out. Call 866-429-7566 for assistance.
Model # 900139: Page 11