RealFlame 5020E Guía De Usuario página 8

Installation (continued)
3. Anchor Chimney to wall (OPTIONAL)
With the back part of the Chimney (E) slid onto the
disk, place the Fireplace (A) against the wall to which
the unit will stay. Measure as shown or mark the wall
at the keyhole in the chimney.
Move the replace and attached chimney out of the
way after marking the location.
Drill a 7/32" hole at the marked location. Insert the
Anchor (D) into the hole so that it is ush with the
surface of the wall.
Inert the screw (F) into the wall anchor (D) and leave a
gap of 3/16" for the chimney to be attached.
4. Complete assembly of the Chimney (E) by sliding the
front of the chimney around the disk on the top of Stove
(A) and line it up with the holes and edge so that it ts
together.
Attach the front and rear Chimney parts together with 5
Screws (C).
Once complete, move the replace back to the wall and
line up the Chimney with the screw in the wall. Place the
keyhole in the back of the Chimney over the screw and
turn slightly to lock into place.
Make sure that the unit is installed so that the power cord is not compressed against or caught on the replace and that it has an unobstructed path to the grounded outlet.
Mark this location
on wall
1
E
A
E
2
C
E
E
A
A