Tabla de contenido
Publicidad
Tighten the top screw and insert housing
screws into all remaining pre-drilled
holes on each vertical housing flange
(2 total per side). Tighten all screws.
Deploy slider bar with latch hook
until it reaches the middle of the
track. Mark the position of the slide
bolts on the sill and top molding.
Interior View
Release the slider bar and drill 1/4" holes
in the sill and the top molding. Deploy
the slider bar with latch hook to the
middle of the track. Drop slide bolts
into these top and bottom holes.
Interior View
Deploy slider bar with latch until it
reaches the middle of the track and
latches onto the hook.
Verify the latch and latch hook align
properly. Latch hook can be adjusted
as needed with a hand screwdriver.
TIP: Latch hook can be oriented either
hook up or down to connect with latch.
If the top slide bolt is not extending
far enough to engage in the drilled
hole loosen the bottom screw on
the slide bolt bracket. Slide the
bracket with the slide bolt fully
extended until it is engaged in the
drilled hole. Re-tighten the screw.
TIP: For a tailored fit around door
moldings, notch each plastic sill
plate extender using a utility knife.
7
Publicidad
Tabla de contenido
