OPERATING ISSUE
Water dripping inside
when unit is cooling.
Water dripping outside
when unit is cooling.
Remote sensing
deactivating
prematurely (some
models).
Room is too cold.
PAGE 13 OF 41
TROUBLESHOOTING CONTINUED
CAUSES
Improper installation.
Unit removing large quantity of
moisture from humid room.
Remote control not located within
range.
Remote control signal obstructed.
Set temperature too low.
Remote sensing activated (on some
models) and remote control located in
hot spot.
1-800-295-5510
Tilt air conditioner slightly to the outside to
allow water drainage. Refer to installation
instructions or check with installer.
This is normal during excessively humid
days.
Place remote control within 20 feet and 120°
radius of the front of the unit
Remove obstruction.
lncrease set temperature.
Relocate remote control or deactivate
Remote sensing.
uline.com
RECOMMENDATIONS
0321 IH-9286