Uline H-9286 Instrucciones De Instalación página 9

REMOTE SENSING FEATURE:
Press Remote
Sensing Button
NOTE: Unit display shows temperature.
NOTE: Remote display is actual temperature at remote control only.
This feature can be activated from the remote control only. Unit must be in a cooling mode. To activate Remote
sensing feature, point remote control toward unit and press "Remote sensing" button. Use " " or " " buttons to set
desired temperature at remote. Set temperature will only be displayed on unit itself. Light on unit control will illuminate
to indicate it receives signal. Light on remote control will pulse each time it sends signal. lt will periodically send this
signal until the feature is deactivated by pressing "Remote sensing" button again. lf unit does not receive Remote
sensing signal during any seven-minute interval, the Remote sensing feature will halt until the unit receives signal from
remote control again. Display on remote control indicates temperature at remote only.
NOTE: Remote sensing function can be terminated either by pressing Remote sensing button again or
main power button on unit.
FAULT CODES:
If the display reads "AS," a sensor has failed. Contact
Uline Customer Service at 1-800-295-5510.
TO CHANGE TEMPERATURE DISPLAY:
Press and Hold Up and Down Buttons
Together for Three Seconds
PAGE 9 OF 41
OPERATION CONTINUED
USER WILL SEE:
Remote Sensing
Indicator
NOTE: The control is capable of displaying
temperature in Fahrenheit or Celsius.
0321 IH-9286