Installation Instructions - TRUSST CT-APP Guía De Referencia Rápida

TRUSST® QRG
Overview
Eye Bolt

Installation Instructions

Setting up the CT-APP is achieved by:
1. Use a 10 mm Allen key to loosen the clamp bolts
2. Slide the clamps to the needed spacing so the CT-APP attaches to both chords on the top of the
truss (up to 20.5 inch).
a. The front clamp allows for 90 mm (3.5 inches) of adjustment to help with spacing between
the backs of video panels and the face of the truss.
b. The rear clamp adjusts to attach to the rear chord of the truss.
3. Once the CT-APP is adjusted for the size of truss being used, re-tighten the clamp bolts and ensure
the clamps are attached to the truss correctly and the clamp-t-handles are snugly tightened.
NEVER move the front clamp from the front slot in the bar to the rear
slot to achieve more spacing between the video panels and the truss. This
may create a load that exceeds the load rating of the CT-APP and could
cause equipment failure, injury, or death. The front clamp must remain in
the front slot, and the rear clamp must remain in the rear slot.
Pinch Point! Keep hands and fingers clear of the clamps while tightening.
CT-APP is designed to attach to the top of standard box truss with 2 in (50 mm) chords. It
will attach to all sizes, up to 20.5 inch box truss.
Coupler
clamp
2
EN