Pioneer KURO KRP-WM01 Manual De Instrucciones página 14

Installation Procedure
Removing the Pioneer display and television
Before beginning this procedure, remove the
power plugs of the Pioneer display and television
and peripheral equipment from their outlets. If
Caution
necessary, also remove the connecting cables on
the peripheral equipment side.
In the case of a 60-inch display, always have
three or more persons on hand when removing
the display. In the case of a 50-inch display, have
Caution
two or more persons on hand.
1
Loosen the fall-prevention screws fixing
the display side fittings.
Fall-prevention screws
• The fall-prevention screws cannot be removed because
they have a stopper. Loosen them until the lower part
of the Pioneer display and television can be pulled
toward you.
• If a security wire is used for fall prevention, be sure to
remove also the wire from the fittings.
14
En
Pioneer display and television
2
After lifting the Pioneer display and
television slightly toward you, remove it
by gently lifting it straight up.