Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Impacting Sound Level dB(A)
Model
† Pressure (L
2115TiMAX
2115TiMAX-A
2115TiMAX-AP
2115QTiMAX
2115QTiMAX-A
2115QTiMAX-AP
2125QTiMAX
2125QTiMAX-A
2125QTiMAX-AP
2115PTiMAX
2115PTiMAX-A
2115PTiMAX-AP
2125PTiMAX
2125PTiMAX-A
2125PTiMAX-AP
† K
= 3dB measurement Uncertainty
pA
* K = Vibration measurement Uncertainty
Sound and vibration values were measured in compliance with internationally recognized test stand-
ards. The exposure to the user in a specific tool application may vary from these results. Therefore,
on site measurements should be used to determine the hazard level in that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132782 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
(ISO15744)
) ‡ Power (L
p
96.6
107.6
93.2
104.2
93.2
104.2
93.2
104.2
93.2
104.2
WARNING
7.
Coupling
8.
Safety air fuse
5.
Hose diameter
6.
Thread size
Free Speed Sound Level dB(A)
(ISO15744)
) † Pressure (L
) ‡ Power (L
w
p
106.3
89.7
89.7
89.7
89.7
‡ K
= 3dB measurement Uncertainty
wA
9.
10. Grease - during assembly
11. Grease - through fitting
Vibration Level
(ISO 28927) m/s²
) Level
*K
w
117.3
7.8
1.8
100.7
7.8
1.8
100.7
7.8
1.8
100.7
7.8
1.8
100.7
7.8
1.8
Oil
45585155_ed7
Publicidad
Tabla de contenido
