Front Panel Leds; Connecting Network Devices - Digitus BLACK RAPID 100 Manual De Usuario

1.3 Package
• One 10/100Mbps switch
• One Manual
• One Power Adapter

2.1 Front Panel LEDs

Power LED
This red indicator illuminates when the Switch is receiving power.
Link/Act (1- 5)
This blue indicator illuminates steadily when a port is connected to a station
successfully, If blue indicator is blinking, it indicates that a port is transmitting or
receiving data on the network.
2.2 Back Panel and Side Panel Features
This network ports are located on the back panel of the switch. The Power port is
located on the side of the switch.
1-5
These ports are connection points for PCs and other network devices, such as
additional switches.
Power
The power port is where you will connect the included power adapter.

2.3 Connecting Network Devices

To connect network devices to the Switch, follow these instructions.
1. Make sure all the devices you will connect to the Switch are powered off .
2. Connect a Category 5 Ethernet network cable to one of the numbered ports on
the Switch.
3. Connect the other end to a PC or other network devices.
4. Repeat steps 2 and 3 to connect additional devices.
5. Connect the supplied power adapter to the power port on the Switch's back
panel.
Note: Make sure you use the power adapter included with the Switch. Using a
different power adapter may result in damage to the Switch.
6. Plug the other end of the adapter into an electrical outlet.
7. Power on the devices connected to the Switch. Each active port's corresponding
LED will light up on the Switch.
Chapter 2 Installation