Mounting The Camera - DJI RSC 2 Guia De Inicio Rapido

F. Powering On/Off and Entering/Exiting Sleep Mode
Press and hold the power button to turn DJI RSC 2 on or off. Tap or press twice to enter
or exit sleep mode.
G. Activating DJI RSC 2
DJI RSC 2 needs to be activated through the Ronin app before using
for the first time.
1. Press and hold the power button to power on the gimbal.
2. Enable Bluetooth on your mobile device and launch the Ronin app.
Note that a DJI account is required to launch the Ronin app. Once
detected in the list of Bluetooth devices, select DJI RSC 2 and input
the default Bluetooth password: 12345678. Make sure you are
connected to the internet and follow the on-screen instructions to
activate DJI RSC 2.

Mounting the Camera

Make sure to prepare the camera before mounting it to DJI RSC 2. Remove the lens cap and
check that the battery and memory card are inserted in the camera. Make sure DJI RSC 2 is
powered off or in sleep mode before mounting the camera.
1. Attach the Upper Quick-Release Plate
The camera lens and the arrow on the bottom of the upper quick-release plate must face
the same direction. Attach the upper quick-release plate to the camera by tightening the
screw.
A camera riser is required when using a focus motor or a small camera with a large lens, such as a
Sony A6400 with the Sony FE 24-70 f2.8 GM lens.
DJI RSC 2 Quick Start Guide
Device Activation
Activation is required prior to using the
device. To do so, information regarding
your device and DJI account will be
u p lo a d e d t o D J I . P le a se a g re e a n d
User Profile
©
2020 DJI OSMO All Rights Reserved.
DJI RSC 2
Creat
proceed to activation.
Agree and activate
Status
5