Smith Performance Sprayers R301 Serie Manual De Uso Y Cuidado página 3

Assemble Hose To Tank
IMPORTANT: Do not attempt to heat or alter hose,
hose nut, or barb prior to assembly.
1. Align hose barb tabs, push hose barb into tank
until it stops (See Figure A).
2. Slide hose nut into place and turn clockwise to
tighten. (See Figure B).
NOTE: Do not use tools to tighten hose nut.
XR Valve
Assemble Hose, Extension, Shut-Off & Nozzle
1. Attach hose to Shut-Off and tighten securely using a 9/16" Wrench, use a 3/4" Wrench to hold the Shut-Off
handle while tightening the hose. (See Figure H)
2. Install the extension onto the Shut-Off assembly and tighten the nut securely using a 13/16" wrench.
(See Figure J)
3. Install selected nozzle into the extension nut and tighten nut securely using a 13/16" wrench. Insert check
valve if required as shown. (See Figure K)
ASSEMBLY INSTRUCTIONS
Figure J
Figure H
BRASS ADJUSTABLE
FAN NOZZLE USES:
Used on
1. Industrial and Concrete Series (Orange)
BRASS FLAT FAN TIP
NOZZLE USES:
Used on
1. Industrial and Concrete Series (Orange)
SPRAY SPRAY FLOW
RATE:
ANGLE: PATTERN:
.2 GPM
65° FAN
80° FAN .2 GPM
80° FAN .4 GPM
80°
FAN .5 GPM
95° FAN .5 GPM
110° 1 GPM
FAN
Figure A
Figure K
CERAMIC CONEJET TIP
NOZZLE USES:
Used on
1. Turf and Argiculture Series (Green)
2. Industrial and Concrete Series (Orange)
3. Cleaning and Restore Series (Blue)
4. Pest Control Series (White)
FLOW
SPRAY SPRAY
ANGLE: PATTERN: RATE:
80° FAN .07 GPM
FAN .10 GPM
80°
80° FAN .10 GPM
80° FAN
.13 GPM
80° .20 GPM
FAN
Figure B
COLOR
#4 GREEN
#6 RED
#10 BLACK
#8 GRAY
#12 BROWN
Page 3