Before Use; Switching The Appliance On - Hilti DD-WMS 100 Manual De Instrucciones Original

4.2 Noise and vibration information (measured in accordance with EN 60335-2-69):
Typical A-weighted emission sound pressure level
Uncertainty for the given sound levels
Triaxial vibration value (vibration vector sum)
Uncertainty for the given vibration value

5 Before use

5.1 Filling the water and waste material container
1. Open the two catches.
2. Remove the filter bag. → page 17
3. Fill the water container with water up to the MAX mark.
Note
When the "Water level too high" warning lamp lights, the appliance cannot be operated.
The water and waste material container must be filled for the "Water supply" and "Recycling"
modes.
4. Insert the filter bag. → page 16
5. Fit the top section of the appliance onto the water and waste material container.
6. Close the two catches.
5.2 Fitting the filter bag
Note
A filter must be fitted for the Vacuum cleaner and Recycling modes.
1. Open the two catches.
2. Lift the top section of the appliance away from the water and waste material container.
3. Attach the filter to the filter holder.
4. Fit the top section of the appliance onto the waste material container.
5. Close the two catches.
5.3 Connecting the hose set to the diamond coring machine
1. Connect the suction hose to the suction hose inlet fitting.
2. Connect the water supply hose to the water supply hose outlet fitting.
3. Connect the other end of the suction hose to the water collector of the diamond core drilling machine.
Note
Use the tapered adapter if necessary.
4. Connect the other end of the water supply hose to the diamond core drilling machine.
6 Operation

6.1 Switching the appliance on

CAUTION
Risk of injury through incorrect operation.
▶ The appliance may be operated only by authorized, trained personnel. This personnel must be
specially informed of any possible hazards.
16 English
Printed: 12.06.2017 | Doc-Nr: PUB / 5306545 / 000 / 03
3
DD-WMS 100
≤ 76 dB
≤ 2 dB
≤ 2.5 m/s²
≤ 0.2 m/s²
2
4