Congratulations on the purchase of this SkyTronic light effect. Please read this manual carefully prior to using the unit.
Warning:
-
Read the manual prior to using the unit.
-
Keep the manual for further reference.
-
Keep the packaging so that you can transport the unit in its original packaging in order to avoid damage.
-
The SkyTec light effect contains a modern halogen lamp of a high light intensity. Do not look into the lamp. This
might damage seriously your eyes.
-
During use, these lamps get very hot. Therefore the light effect must be placed at least 50 cm away from
inflammable materials such as curtains, books, etc. Make sure that the housing cannot be touched by accident.
-
For indoor use only.
-
During installation, nobody should stand beneath the mounting area.
-
Prior to the first use, have the unit checked by a qualified person.
-
The unit contains voltage carrying parts. DO NOT open the light effect.
-
Unplug the unit from the mains prior to repairs, maintenance and replacement of the lamp.
-
Never plug or unplug the unit with wet hands.
-
Disconnect the unit from the mains prior to replacing the fuse.
-
If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
-
If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet.
-
Repairs and lamp replacement has to be carried out by a qualified technician.
-
Only connect this unit to an earthed mains outlet of 230 VAC / 50 Hz.
-
Always unplug the unit during a thunderstorm or when it is not in use.
-
If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please let the
unit reach room temperature prior to use.
-
When you unplug the unit from the mains always pull the plug, never the lead.
-
In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a steel
cable, etc. which has to be fastened separately from the mounting bracket.
-
The supplied bracket is the main fixing and must be used to solidly mount the light effect.
-
In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings must be
fulfilled.
-
Keep out of the reach of children.
Installing/replacing the lamps
1.
Before replacing the lamp, unplug mains lead and let the lamp cool down. Please follow the lamp manufacturer's
notes when installing.
2.
For the installation, you need an appropriate UV-tube.(see technical specifications)
3.
Unscrew the fixation screws of the protective grid.
4.
Remove the protective grid.
5.
Insert the UV lamp into the lamp socket.
6.
Replace the protective grid and tighten the screws.
7.
Do not operate this device with opened protective grid!
Operating Determinations
-
This device is a lighting effect for creating decorative effects. This product is only allowed to be operated
with an alternating voltage of 230V 50Hz and was designed for indoor use only.
-
The minimum distance between light-output and the illuminated surface must be more than 0.5
meters.
-
Always fix the fixture with an appropriate safety-rope.
-
Operate the device only after having familiarized with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation!
-
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture.
-
This device falls under protection-class I. The electric connection must be carried out by a qualified
employee.
-
Connect the fixture to the mains with the power plug.
-
After you connected the spot to the mains, the lamp needs 3-4 minutes warm-up time until it reaches full
lighting output.
GB