Chicco Cuddle & Bubble Comfort Manual Del Usuario página 11

the front upper tubular frame, lining up the
two pins of basket C1 with the holes in the
tubular (fig. 7).
7. At this point hang the head wash C2 to the
right of the storage basket C1, by sliding it ver-
tically downwards into the guide (fig. 8).
8. Hook the sponge basket C3 fitted with lid to
the left of the storage basket C1 by sliding it
vertically downwards into the guide (fig. 9).
9. The product contains a storage basket that
can be placed in the centre of the shelf A1 to
ing the side slots on the tub with the fixing
blocks (fig. 11-12). Complete the assembly
of the tub by inserting the rubber plug B1 in
the relevant slot and pressing the base of the
plug (fig.11A) while rotating it in the relevant
hole (fig. 11B).
11. Complete assembly by lifting the changing
table A2 and turning it to position it onto the
tub B (fig. 13).
changing table A2, make sure that the securing
straps A7 correctly engage clamps A6 through
the release buttons until you hear a click (fig. 13A
- 13B).
Using the reducers
To ensure maximum comfort and ergonomics of
the changing table for use in the first months of
a child's life, use the reducer in padded fabric C5
supplied (Fig. 16).
The reducer C5 can be removed or secured to
changing table A2 through the holes and velcro
found on product (fig. 14-15).
WARNINGS FOR THE TUB
Age of use allowed: from birth up to 12
months and 11kg. For home use only.
WARNING: To avoid risk of drowning, always
keep the child under hand. The child can
drown in the tub in only a brief time and little
water (2 cm).
never leave the child unattended.
WARNING:
leave the child unattended during the bath. Do
not answer the phone or open the door. Al-
ways take the baby with you if it is necessary to
leave the bathroom.
tables or the edge of the bath tub for adults).
the tub can support it.
flat, dry and stable surface. The stability of the
tub should be checked before and during use.
tub.
WARNING: To avoid burns, before placing the
child in the tub pay attention to water temper-
child cannot access the tap.
-
bath, check that the water temperature with a
thermometer is correct.
the plug is seated properly.
filling level of the tub.
has been fitted correctly.
bath, make sure that the changing table is
always secured in place from the side of the
frame.
near the product.
USING THE WASH TUB
The tub B supplied can be used as follows:
over on its back side (fig. 18).
Before use, fasten the safety strap A8 to the fa-
stening block A6 (fig. 28A).
19).
move drain plug and hose B2 by unscrewing it
to ensure product stability (fig. 21).
maximum level indicated by the appropriate
symbol on the inner surface of the tub B (fig. 22).
positioned in the dedicated grip on the short
side of the tub B (fig. 23).
ting the baby inside the tub.
11
-
-