Product Maintenance - Fellowes POWERSHRED P70CM Manual De Instrucciones

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4 minutes will trigger a
20-minute cool down period.
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse (R)
for 2-3 seconds

PRODUCT MAINTENANCE

OILING SHREDDER
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
PAPER/CARD
1 2
Set to Auto-On (I) Feed paper/card
straight into paper
entry and release
3 4
Set to Off (O)
and unplug
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to On (I)
3
When finished shredding
set to OFF (O)
5 6
Gently pull uncut Set to Auto-On (I) and
paper from paper resume shredding
entry. Plug in.
2 3
Set to Reverse (R)
Apply oil*
for 2-3 seconds
across entry
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Wait 20 minutes for motor to cool down.
3