Installing The Light Kit - HAMPTON BAY Scottsdale Manual Del Propietário

Installing the Light Kit

CAUTION To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing
Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping. Please follow these steps to
complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1.Remove 3 screws on compartment box cover.
(Figure 18)
2. While holding the light kit assembly under
your fan, snap together the wire connection
plug. (Figure 18)
3. Carefully push all wires
compartment box, then install the light kit
assembly onto the compartment box cover with
the 3 screws previously removed. Be sure to
tighten all screws. (Figure 18)
4. To install light kit glass shade, loosen the
socket ring on the light kit and install the
Light
glass shade to the light kit. Secure by
tightening the socket ring previously
loosened
5. Install 3*13W CFL. (included)
6. Restore power and your light kit is ready
for operations.
NOTE:
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND
THE BULBS TO THE CHAIN DOESN 'T RUB
AGAINST ANY OF THE BULBS. LIGHT
BULBS HAVE NO WARRANTY, CAN BE
P U R C H A S E D A T L O C A L H O M E
IMPROVEMENT STORE OR FROM OUR
SERVICE CENTER.
back into the
. (Figure 19)
Housing
Screw
Compartment
box
Light kit
Socket ring
Figure 18
Housing
Figure 19
Compartment
box cover
Wire connection
plug
8