Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
1. Treadmill is not plugged in.
2. Safety key not properly
installed.
The treadmill does
not start.
3. Home fuses may have
tripped.
4. Treadmill fuse has tripped.
The treadmill slides.
Belt is not tight enough.
The belt does not
1. Not enough oil applied
move correctly when
between belt and base.
in use.
2. The belt is too tight.
Belt is not centred on
The tension of the belt on
rear roller.
one side is not the same as
the other.
Do not dispose of this product as you
would other household waste. Dispose
of this product in accordance with the
corresponding local regulations.
Electrical
and
electronic
contain hazardous substances that can
have harmful effects on the environment
and/or human health and should be
recycled properly.
Quality Warranty:
This product is covered by a warranty
against manufacturing defects subject
to the time periods stipulated by the
legislation in force in each country.
This warranty does not cover damage
resulting from inadequate use, negligent
commercial use, abnormal wear and tear,
accidents or improper handling.
Australia & New Zealand only
This product has the benefit of certain
Consumer
Guarantees.
prescribed by the Australian Consumer
Law & the New Zealand Consumer
Cause
1. Plug the power cable into
the mains.
2. Reinstall safety key.
3. Reset fuse or call electrician.
4. Wait 5 minutes and then try
restarting treadmill.
Tighten belt.
1. Buy and apply oil.
2. Tighten belt.
Centre the belt.
Guarantees Act 1993 both of which
provide protection for consumers. There
is no express warranty for this product
in Australia or New Zealand. The above
appliances
paragraph refers to other countries.
Made in China
These
are
Corrective Action
17
Publicidad
