Telstar TAI012112MD Manual De Instrucciones página 27

CARE AND MAINTENANCE
Plasma
(optional)
Open the panel and take down
the Plasma filter by holding the
upper of the Plasma and lifting it
s
upwards according to the
arrows.
For the models with plasma, do not touch the plasma within 10 minutes after you open
the panel.
5. Install the air freshening filter back into position.
6. Insert the upper portion of air filter back into the unit, taking care that the left and
right edges line up correctly and place filter into position.
Replacement of air filter and air freshening filter
1. Remove the air filter.
2. Remove the air freshening filter.
3. Install a new air freshening filter.
4. Reinstall the air filter and securely close the front panel.
Preparation for extended non-operation
If you plan to idle the unit for a long time, perform the following:
1. Clean the indoor unit and filters.
2. Operate the fan for about half a day to dry the inside of the unit.
3. Stop the air conditioner and disconnect power.
4. Remove the batteries from the remote controller.
The outdoor unit requires periodic maintenance and cleaning. Do not attempt to do
this yourself. Contact your dealer or service provider.
Pre-season inspection
Check that the wiring is not broken off or disconnected.
Clean the indoor unit and filters.
Check that the air filter is installed.
Check if the air outlet or inlet is blocked after the air conditioner has not been used for a
long time.
CAUTION
-Do not touch the metal parts of the unit when removing the filter. Injuries can occur
when handling sharp metal edges.
-Do not use water to clean inside the air conditioner. Exposure to water can destroy the
insulation, leading to possible electric shock..
-When cleaning the unit, first make sure that the power and circuit breaker are turned
off.
-Do not wash air filter with hot water at more than 40OC/104OF. Shake off moisture
completely and dry it in the shade. Do not expose it directly to the sun, it may shrink.
Releasing the buckles as
indicated with arrows and
open the cover of the Plasma,
clean or replace the filter.
2