Interrupting Operation; Ending Operation; Using Detergents; Cleaning And Maintenance - Grizzly HDR 21-150 Traducción Del Manual De Instrucciones Original

Locked
Open

Interrupting operation

• Release the lever of the gun (1).
• During prolonged work intervals turn
off the washer by its ON / OFF switch
(10).
If the equipment falls over,
switch off the equipment immedi-
ately at the on/off switch (10) and
disconnect the equipment from
the mains at the mains power
cord (5). Risk of electric shock!
Only now should the equipment
be returned to an upright posi-
tion. For your own safety, wait
approx. 5 minutes before recon-
necting to the electricity.

Ending operation

1. After having worked with a detergent
rinse the washer with clear water.
2. Release the lever of the gun (1).
3. Turn off the pressure by its ON / OFF
switch (10). Disconnect the mains
plug.
4. Turn off the water tap.
5. Disconnect the pressure washer from
the water mains.
6. Pull the lever of the gun (1) to vent the
pressure existing within the system.
7. You can fold the bow-type handle
downwards in a place-saving manner
through a resistance.
8. The crank handle of the hose drum
can be folded after unlocking the slide
latch.

Using detergents

The washer was designed for operation
with a neutral detergent based on a bio-
logically decomposable anionic tenside.
Other detergents or chemical substances
could impair the safety of the washer and
damage it. Such damage to the equip-
ment is not covered by the guarantee.
Fill/drain detergent:
• To add cleaning agent to the jet, you
must first fill the cleaning agent tank
(15).
• To remove the cleaning agent tank
(15), hold it on the side and push it
upwards. You can now pull the clean-
ing agent tank out of the bottom and
side guides on the pressure cleaner.
Mind to first remove the induction
hose and the cap from the opening of
the cleaning agent tank (16) as they
will remain on the pressure cleaner.
• To reinstall the cleaning agent tank
(15), trace back the above steps.
Working Instructions:
• Operate the jet tube with flat spray
nozzle (18) in low-pressure mode to
automatically add cleaning agent to
the water.

Cleaning and Maintenance

Pull out the power plug before
every maintenance operation. This
also includes connecting to the
water supply or trying to eliminate
leaks. There is a risk of electrocu-
tion or of injury from moving parts.

Cleaning

Never direct the water jet
against the washer, nor clean
the washer under flowing water.
This could give rise to the dan-
ger of electric shock and dam-
age the washer! .
GB
21