Replacing The Ribbon Cassette - Uline H-2812 Manual De Instrucciones

REPLACING THE RIBBON CASSETTE

1. Open the unit. Refer to "Open Unit" on page 5.
2. Hold the ribbon cassette by its tab and pull the
ribbon cassette straight out to remove it.
(See Figure 56)
Figure 56
3. Turn the knob of the new ribbon cassette in the direction
of the arrow (clockwise) to tighten the ribbon.
(See Figure 57)
Figure 57
4. Install the ribbon cassette inside the unit as shown.
Push the ribbon cassette until it snaps into position.
(See Figure 58)
Turning the knob on the ribbon cassette may
make installation easier.
Figure 58
PAGE 17 OF 57
OPERATION CONTINUED
Figure 59
5. Turn the knob of the ribbon cassette in the direction of
Figure 60
6. Close the unit. Refer to "Close Unit" on page 5.
Install the ribbon cassette so that the ribbon is
between the print head and the ribbon mask.
Printing will not function properly if the ribbon is
placed behind the ribbon mask. (See Figure 59)
Ribbon
the arrow to tighten the ribbon. (See Figure 60)
Print Head
Ribbon Mask
0721 IH-2812