Fuse Replacement - Chauvet TechnoStrobe 168 Guía De Referencia Rápida

EN
Product
Description
Product Overview
AC Power
Power Linking

Fuse Replacement

DIP Switches
All-On
Operation
The Techno Strobe™ 168 is a lightweight LED strobe light with very low
power consumption and built-in speed and intensity settings. Perfect for
special events and the mobile entertainer, the Techno Strobe™ 168 can be
operated in standalone or DMX modes and can strobe all night.
DMX In/Out
DIP Switches
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 34 Techno Strobe™ 168 products at 120 VAC and 57
units at 230 VAC.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Automatic and standalone modes can be accessed without DMX through
the DIP switches located on the back panel. If you are unfamiliar with DIP
switches, download the DMX Primer from www.chauvetlighting.com.
Due to its innovate design, this unit can be run strobing all night, but
continuous All-On operation should not be used for more than 30 minutes
at 120V or 15 minutes at 230V.
Techno Strobe™ 168 QRG
Back Panel View
3
Power Out
Power In
Fuse Holder
Intensity
Adjustment
Speed
Adjustment