Troubleshooting - Imetec M3901 Instrucciones Para El Uso

This chapter describes the most common problems that can arise using the appliance. If
the problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The plate (10)
remains cold or
does not heat up.
The plate
temperature LED
(1) goes on and off.
Only a little steam
or none at all is
dispensed.
The impurities that
come out from the
steam holes stain
the garments.
Water leaks from
the plate.

TROUBLESHOOTING

Possible cause
There is no power supply.
Normal procedure.
The steam selector (5) is set
to Ø.
There is not enough water in
the reservoir (11).
Possible residue in the
steam chamber/plate.
Chemical additives, scented
liquids or descaling agents
are being used.
Pure distilled water or
softened water is being
used.
Starch is being used.
The plate temperature is too
low due to the super-steam
button (4) being pressed too
often.
The temperature adjustment
knob (2) is set to a
temperature that is too low
(Fig. D).
Solution
Verify whether the plug (13) is
inserted correctly or try inserting it in
another socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature Ø (Fig. D).
The switching ON and OFF of the
LED indicates the heating phase of
the iron. The LED goes off once the
set temperature is reached.
Set the steam selector (5) to the
desired field [Fig. B].
Fill the reservoir (11).
Carry out the Self Clean procedure
(see paragraph Seal Clean/Calc-
Clean System).
These substances damage the
product: do not add additives to the
water in the reservoir.
Mix tap water (50%) with distilled
and/or demineralised (50%) water.
Always spray the starch on the
reverse side of the fabric.
Allow slightly longer intervals
between the jets of steam.
Turn the temperature adjustment
knob (2) to the Max level (Fig. D).
EN
17