Trevi MPV 1710 SB Guia Del Usuario página 12

MPV 1710 SB
BLUETOOTH MODE
PAIRING OPERATION
1. Press and hold the ON/ OFF button (7) to turn on the speaker.
2. The voice guide will indicate '"CONNECTION" and the speaker will start in the search mode to connect
with the devices available.
3. Activate Bluetooth on your device and search for the speaker named "MPV1710SB", enter the PIN
"0000" if required.
5. After connection, the LED indicator (2) will flash more slowly.
6. Press and hold the MODE button (6) to unpair the connected device and make a new pairing procedure.
NOTE:
- When connected in BT mode, the speaker device also acquires the functionality of input device,
like an external keyboard, to enable the remote control to capture photos. This means that the
keyboard of device can be disabled to enter text. In this case you can control your device using voice
commands or by selecting Bluetooth from the Settings menu and from the list of available input devices
select Options (or Settings) of device MPV1710SB; then remove the check from the voice Input device.
At this point, the keyboard of the device back to its normal operation, but is disabled remote shutter for
capturing photos key of MPV1710BT. To use the speaker as remote control of acquisition select and
active again the voice Input device. The steps described above can vary from device to device.
- The Bluetooth speaker will go into sleep mode automatically after a certain inactivity time, emitting a
warning sound, to turn it back just press the ON OFF button (7).
- The Bluetooth speaker only works with one connection at a time, the connection can not be interrupted
All manuals and user guides at all-guides.com
ENGLISH