DeWalt DC610 Manual De Instrucciones página 31

Make sure the protective cap is in place
before storing or carrying a detached
battery pack.
Automatic refresh
The automatic refresh mode will equalize
or balance the individual cells in the
battery pack at its peak capacity.
Battery packs should be refreshed
overnight after every 10th charge/
discharge cycle or whenever the pack no
longer delivers the same amount of work.
• To refresh your battery pack, place the battery
in the charger as usual. The red light will blink
continuously indicating that the charge cycle
has started.
• When the 1-hour charge cycle has completed,
the light will stay on continuously and will
no longer blink. The pack is fully charged
and can be used at this time.
• If the pack is left in the charger after the initial
1-hour charge, the charger will automatically
initiate the refresh mode. This mode will continue
up to 8 hours, but the battery pack can be
removed at any time during the refresh mode.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot
or too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has
reached an appropriate temperature. The charger
then automatically switches to the pack charging
mode. This feature ensures maximum battery life.
The red indicator blinks long, then short while in the
Hot/Cold Pack Delay mode.
Low battery indicator (fig. A)
The low battery indicator is an integrated feature in
the headlights (4). It will blink 4 tmes to indicate that
the battery pack needs to be recharged and the tool
will automatically shut down.
• Switch off the tool and take out the battery pack
(9) to charge it as soon as the indicator blinks.
The tool remains non-operational as long
as a low battery pack is attached to it.
DC610 - Battery type
The tool will operate on battery packs
of 12 and 14.4 volt.
Refer to the table in the back for a selection
of applicable battery packs.
Mounting the belt hook (fig. C)
• Insert the belt hook (8) into the mounting hole
on either side of the tool.
• Pass the screw (14) through the mounting hole
in the opposite side. Tighten the screw.
Loading the tool (fig. D)
The tool can be loaded using either of the below
methods.
Lock and load method
• Lock the nail pusher (15) in the back position.
• Select an appropriate collated nail stick.
See "Technical data".
• Insert the nails into the loading slot in the bottom
of the magazine (6).
• Unlatch the nail pusher by pulling rearward
and carefully slide the nail pusher forward
to press against the nails.
Load and draw method
• Insert the nails into the loading slot in the bottom
of the magazine (6).
• Draw the nail pusher (15) back until behind
the nails.
• Release the nail pusher to press against the nails.
Unloading the tool
• Lock the nail pusher (15) in the back position.
• Remove the nails from the magazine (6).
Adjusting the driving depth (fig. E)
The driving depth can be adjusted to the type
of fastener used.
• Adjust the driving depth as required,
choosing a setting from 1 (shallow) to 6 (deep).
• To reduce the depth, turn the depth adjustment
wheel (3) clockwise.
• To increase the depth, turn the depth adjustment
wheel counterclockwise.
E N G L I S H
31