Kenwood KAH647PL Instrucciones página 7

This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using your Kenwood
attachment
Remove all packaging including the
G
plastic blade covers from the knife
blade. Take care the blades
are very sharp. These covers
should be discarded as they are to
protect the blade during
manufacture and transit only.
Wash the parts see 'cleaning'
G
key
pushers: large and small
feed tube
attachment lid
finger grip
knife blade
attachment bowl
connector
cutting discs
1 extra fine grating disc
2 fine grating disc
3 coarse grating disc
4 thin slicing disc
5 thick slicing disc
6 julienne disc
knife blade
Use on speed 2 to 5
Use the knife blade to chop raw
and cooked meat, cooked eggs,
vegetables, nuts, pâtés and dips
and to also make crumbs from
bread and biscuits. It can also be
used to make shortcrust pastry
and crumble toppings.
maximum capacities
pastry (flour weight) 400g
G
meat 500g
G
Never exceed the 'max' level
G
marked on the bowl.
to use the knife blade
1 Place the kitchen machine on the
work surface with the speed
control facing the front.
2 Lift off the high speed outlet cover
.
3 Place the connector onto the outlet
with the triangle M facing towards
you and turn clockwise until it
locks into position.
4 Place the bowl onto the connector
with the handle at the back of the
kitchen machine then turn
clockwise to lock in place.
5 Place the knife blade in the
attachment bowl. Turn and push
down if necessary to locate.
Handle the knife blade with
care - the blades are
extremely sharp. Hold by the
finger grip.
6 Cut the food up and place into the
bowl ensuring it is evenly
distributed.
7 Fit the lid onto the bowl by placing
the feed tube behind the handle
then push down and turn
clockwise to lock in place. The lid
can be fitted in four different
positions.
If you experience difficulty in
G
fitting the lid, remove the
attachment and switch on
the kitchen machine briefly.
Refit the attachment.
8 Fit the pushers.
9 Switch on and select a suitable
speed. Process until the desired
result has been achieved.
10 Switch off and unplug.
11 Remove the attachment from the
outlet by turning anti-clockwise
and lifting off. Dismantle the
attachment. (To remove the bowl
from the connector, hold the base
of the connector and turn the bowl
anti-clockwise and lift off
experience difficulty in removing
the connector from the bowl, refit
the bowl and connector to the
outlet. Turn the assembly anti-
clockwise until it reaches a stop,
then turn the bowl further to unlock
from the connector
4
. If you
.)