REMOVING THE SHAVER COVER (Diagram G)
Gently push the buttons either side of the shaving foil. With the other hand lift the
REPLACING THE CUTTER ASSEMBLY
Hold the Trimmer in one hand. With your other hand, insert the lower part of the
REPLACING THE TRIMMER COMB AND SHAVER ATTACHMENT
(Diagram H)
Hold the Trimmer in one hand with your thumb fi rmly on the Zoom wheel to keep
Slide the comb/shaver down the grooves until it clicks into place.
NOTE: The trimmer comb and shaver attachment can only be attached in one way.
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that
the foil and cutter are replaced regularly.
Signs that your foils and cutters need replacing:
Replacement cutters and foils available. Model: SP02.
CARE FOR YOUR TRIMMER
Care for your product to ensure a long lasting performance. We recommend you clean your
shaver after each use. The easiest and the most hygienic way to clean the shaver is by rinsing
the product head after use with warm water. Always keep the trimmer in the "off" position
when not in use.
AFTER EACH USE
Turn Trimmer off.
Remove the adjustable trimmer comb and cutter assembly or shaver attachment.
Gentle tap on a fl at surface to remove hair particles, and brush the remaining hairs
CLEANING CAUTIONS
Only the adjustable trimmer comb and cutter assembly may be removed from the
4
B H T 2 0 0 0 . i n d d 4
ENGLISH
shaver cover. Clean then replace.
cutter assembly into the Trimmer, push down the cutter until fi rmly attached.
it from turning. Ensure that the Length Position Indicator is at 1.
If it does not go on correctly, turn it around and try again.
1. Irritation: As foils get worn, you may experience skin irritation.
2. Pulling: As the cutters wear, your shave may not feel as close and you may feel your
cutter pulling your hair.
3. Wear through: You may notice that the cutters have worn through the foils.
away/rinse under warm water (Diagram I).
Trimmer for cleaning.
0 3 . 0 6 . 2 0 0 5
9