EUROM HVF14-2 Instrucciones página 6

 Never immerse the device, cable or plug in liquid!
 First turn off the fan and then remove the plug from the socket before moving, cleaning or
carrying out maintenance.
 Do not expose persons (in particular babies, elderly people and immobile persons) to the
cold air stream for a long period.
 Never leave an operating fan without supervision; switch it off and remove the plug from the
wall outlet. Always remove the plug from the wall outlet if the fan is not used. Never pull the
electric cable, but grab the plug.
 Ensure strict supervision when using the fan in the presence of children, incapacitated
persons or pets. This device is not suitable to be used by children or persons with a physical,
sensual or mental disability or those who lack experience and knowledge, irrespective of
whether they are being supervised or there is a responsible person present. Keep these
persons and household pets out of the vicinity of the fan.
 This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
 This device should only be used for the purposes set out in the booklet. Any other usage may
be dangerous (could cause fire, injury, damage, electric shock etc), will invalidate the
guarantee and no liability will be taken by the supplier.
ASSEMBLY (only HVF18-2S)
1 = Fan body including frame
2 = Telescopic stand
3 = Holder
4 = Decorative cap
5 = Foot
6 = Large screw including plate
8 = Clamping screw
 Put the holder (3) together with the telescopic
stand (2) in the foot (5); there are recesses to
attach the screws to the foot.
 From the bottom side, insert the large screw
together with the plate (6) through the foot into
the holder and turn the holder tightly onto the
foot.
 Put the holder including the foot in an upright
position and slide the decorative cap (4) over
the fastening.
 Slide the mounting tube of the frame (1) into
the telescopic stand (2) (see the illustration.),
screw holes should align with screw holes. Insert both screws through the telescopic stand
into the mounting tube. Tighten them using both nuts.
 Set the required height by (a) loosening the clamping screw (8), (b) setting the telescopic
stand to the required height and (c) tightening the clamping screw.
 Check that everything is secured properly. Never use the fan before it has been fully
assembled!
6