Troubleshooting; Technical Specifications - cecotec ROCKSTAR 700 ULTIMATE ERGOFLEX Manual De Instrucciones

Allow them to dry completely before installing and using them again.
Fig. 14
Jalisco brush
Recommendation: It is important to clean the brush regularly to avoid hair and other foreign
objects from tangling and to prevent blockages.
Press the brush release button on the bottom part of the suction base and remove the brush.
Wash it with warm water. Do not use detergents or soap.
Make sure it is completely dry before installing it back in the device.
Fig. 15

6. TROUBLESHOOTING

Problem
The motor does not
operate.
Suction power level is
very low.
The operating time after
charging has decreased.
Green and red light
blinking.
Note: For any further doubt, please contact the official Technical Support Service of Cecotec.

7. TECHNICAL SPECIFICATIONS

Model: Conga RockStar 700 Ultimate ErgoFlex
Battery: 25,9 DC, 2500 mAh
Product reference: 05493
Voltage and frequency: 100-240 V ~, 50/60 Hz
Made in China | Designed in Spain
Possible reason
No battery.
The vacuuming tube, brush,
battery, suction base or
handheld vacuum cleaner are
not assembled in place.
The dust tank is full.
Filters are dirty or blocked.
Air inlet of the vacuuming
tube or suction base are
blocked.
It has not been enough
charged.
Battery is damaged or too old.
The charger is not connected
to the mains.
Solution
Charge the vacuum cleaner.
Check that the components
and the handheld vacuum
cleaner are assembled
correctly.
Empty the dust tank.
Clean or replace the filter.
Clean the dirt attached to the
brush.
Charge the battery
completely.
Replace the battery.
Plug the charger to a socket
base.
ROCKSTAR 700 ULTIMATE ERGOFLEX
ENGLISH
41