Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Product Assemblies
SP-ECW10-1-35-W
Place installation template on cabinet
1
floor. Drill 4 holes at locations shown on
template with 1/16" drill bit. Once the
position is determined, fasten the sliding
base assemblies to the cabinet floor by
using 2 – #8 x 1/2" mounting screws for each
slide assembly shown in image 1 below.
Tighten with a Phillips head screwdriver.
Fully extend slides out of cabinet and then
2
install 1/ea cage mounting clip bottom onto
each slide by fastening with 2 – #6 x 3/8"
cage mounting screws as shown in images
2a and 2b.
Place wire cage on top of the cage mounting
3
clip bottoms as shown in image 3 below.
Then install each cage mounting clip tops
with 2 – #6 x 3/4" cage clip screws as
shown in image 4.
With slides fully extended insert the bin
4
into the cage.
Grand Rapids, MI
800.253.1561
simplyputorganizers.com
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Parts Included
Waste Bin (1)
Wire Cage (1)
1
2
b
3
WIDE
INSTALLATION
NARROW
INSTALLATION
©2017 Knape & Vogt. All rights reserved. Knape & Vogt
Single Pullout Waste Bin
Cage Mounting Clips (2)
Slide Assemblies (2)
NARROW INSTALLATION
USES 2
ND
AND 4
HOLE BACK
reserves the right to change specifications without notice.
®
Installation Instructions
#6 x 3/8 Large
6 x 3/4" Cage Clip
Mounting Screws
Screws (4)
#8 x 1/2" Mounting
Installation Template
Screws for Slide
(not shown)
Assemblies (4)
2
a
TH
WIDE INSTALLATION
USES 1
ST
AND 3
HOLE BACK
4
RD
310582/0917
Publicidad
Manuales relacionados para simplyput SP-ECW10-1-35-W
Resumen de contenidos para simplyput SP-ECW10-1-35-W
- Página 1 Slide Assemblies (2) #8 x 1/2" Mounting Installation Template Screws for Slide (not shown) SP-ECW10-1-35-W Assemblies (4) Place installation template on cabinet floor. Drill 4 holes at locations shown on template with 1/16" drill bit. Once the position is determined, fasten the sliding base assemblies to the cabinet floor by using 2 –...
- Página 2 Plantilla de instalación de productos deslizabless (2) para los ensambles (no se muestra) SP-ECW10-1-35-W deslizables n.° 8 x 1/2" Ubique la planilla de instalación en el piso del gabinete. Realice 4 perforaciones en los lugares que se muestran en la plantilla con la broca de 1/16".