Assembling Instructions - Mellerware Loopy! Manual De Instrucciones

ASSEMBLING INSTRUCTIONS

FIG.1
Place the front stabilizer (9) to the
–
main frame (1) using the screws
provided.
Place the rear stabilizer (8) to the
–
main frame (1) using the screws
provided.
FIG.2
Place the seat (5) to the seat post
–
(6) with the screws provided.
FIG.3
Place the seat post (6) into the
–
frame (1) and line up the holes.
Secure the seat in position with the
–
seat regulator knob (17).
FIG.4
Place the handlebar (2) to the
–
frame (1) and fix it with the screws
provided.
FIG.5
Fix the monitor holder (4) on the
–
handlebar (2).
Fix the monitor (3) on the monitor
–
holder (4).
Connect the monitor cable to the
–
input behind the monitor.
FIG.6
Fix the pedals (7) into its crank arm.
–
The right-hand pedal, marked with
–
letter R, screws onto the right-
hand crank, also marked with R, in
clockwise direction till tight.
The left-hand pedal, marked with
–
letter L, screws onto the left-hand
crank, also marked with L, in a
counter-clockwise direction till
tight
Instructions for use
USE
The monitor will turn on
–
automatically when users start
exercising.
The monitor will turn off
–
automatically if there is not any
operation for 4 minutes.
Press MODE button to select the
–
function you want.
Press RESET button to reset the
–
function you want. Hold the button
for 3 seconds to clear all values.
TIME → 00:00 – 99:59 MIN:SEC
–
SPEED → 0.0 – 99.9 KM/H
–
DISTANCE → 0.00 – 999.9 KM
–
CALORIES → 0.0 – 9999 KCAL
–
PULSE → 40-240 BPM
–
HOW TO ADJUST THE INTENSITY
REGULATOR KNOB
The intensity regulator knob (D)
–
allows you to alter the resistance
of the pedals. A high resistance
makes it more difficult to pedal, a
low resistance makes it easier.
HOW TO ADJUST THE SEAT HEIGHT
The seat height can be adjusted by
–
removing the seat regulator knob
(F) and raising or lowering the seat.
EN