Worx NITRO WX697L Manual Del Usuario página 9

NOTE: When plunging and sawing use a slight pendulum
motion, to allow sufficient chip removal.
The saw blade lasts longer if the wear is distributed evenly.
To ensure an even distribution, loosen the saw blade, rotate it
and retighten firmly.
Cut/Sand with a constant movement and light pressure.
Heavy pressure does not increase the cut/removal rate – the
accessory merely wears faster.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially when used
at low speed, set the speed to maximum and run it with
no load for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the blade sharp.
Always ensure the workpiece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of the
cutting or sanding finish.
Start your tool before working and turn it off only after you
stop working.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away , it will damage the
sanding pad. The guarantee does not cover sanding pad
wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for finishing surfaces. If
necessary, first make a test run on scrap material.
Excessive force will reduce the working efficiency and
9
cause motor overload. Replacing the accessory regularly
will maintain optimum working efficiency.
MAINTAIN TOOLS WITH CARE
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
FOR BATTERY TOOLS:
The ambient temperature range for tool and battery use and
storage is 0 C-45 C (32°F-113°F).
o o
The recommended ambient temperature range for the
charging system during charging is 0 C-40 C (32°F-104°F).
o o
20V Cordless Brushless Oscillating Tool EN