GreenWorks Commercial GE 080 Manual Del Propietário página 10

ASSEMBLY
W A R N I N G
If any parts are damaged or missing, do not operate this product until the parts are replaced. Use
of this product with damaged or missing parts could result in serious personal injury.
W A R N I N G
Do not attempt to modify this product or create accessories not recommended for use with this
edger. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
W A R N I N G
To prevent accidental starting that could cause serious personal injury, always remove the battery
pack from the product when assembling parts.
ATTACHING THE WHEEL (See Figure 2.)
1. Remove the wing nut (1), washer (2), axle sleeve (3), wheel (4), axle sleeve (3), rubber
washer (5) and wheel axle (6) orderly from the wheel assembly.
2. Insert the wheel axle(6) into the slot (7) downward, then put the rubber washer (5), axle
sleeve (3), wheel (4), axle sleeve (3), washer (2) and wing nut (1) orderly through the wheel
axle (6).
3. Tighten the wing nut (1).
7
1
2
3
4
3
5
6
6
5
3
10
4
3
2 1
Fig. 2.1
Fig. 2.2