Operation - Senix CS4QL-L1 Manual Del Operador

General
1. Check the chainsaw as well as bar and chain for
damage before each use. Do not use the product if
it is damaged or shows wear.
2. Check the fuel level, engine oil level and chain oil
level, refill if necessary.
3. Always hold the product on its handles. Keep the
handles dry and free from lubricant to ensure safe
support.
4. Ensure that the air filter is always unobstructed and
clear. Clean them if necessary, with a soft brush.
Blocked air filter may lead to overheating and
damage the product.
5. Switch the product off immediately if you are
disturbed while working by other people entering
the working area. Always let the product come to
complete stop before putting it down.
6. Do not overwork yourself. Take regular breaks to
ensure you can concentrate on the work and have
full control over the product.
WARNING
In some communities regulations define at what
time of the day and on what special days products
are allowed to be used and what restrictions apply!
Ask your community for detailed information and
observe the regulations in order to preserve a peaceful
neighborhood and avoid committing administrative
offences.
Engine oil check ( black cap )
1. For the first use: Open the engine oil tank cap,pour
100ml of 4-cycle engine oil provided into the engine
oil tank.
2. For further use: Open the engine oil tank cap and
check the oil level. If the oil level is more than 0.39-
0.79in.( 10-20 mm ) blow the screw thread, please
fill the oil tank.
2. Do not overfill and leave approximately 0.20in.
WWW.SENIXTOOLS.COM
Fig. 3
OPERATIONS
( 5 mm ) space between the top of the oil and the
inside edge of the tank to allow for expansion(Fig.
3).
3. Tighten the cap firmly.
Chain lubrication oil
WARNING
The product is not filled with bar and chain oil. It is
essential to fill the product with bar and chain oil before
using it! Never operate the product without bar and
chain oil as this will result in extensive damage to the
product!
If the oil level decreases to below one quarter capacity,
refill it with the proper bar and chain oil. To fill the oil
reservoir:
Operating the saw chain dry or with too little bar and
chain oil will decrease cutting efficiency, shorten the
product life span and cause rapid wear to the saw chain
and guide bar from overheating!
Insufficient bar and chain oil is evident by smoke or bar
discoloration! Adequate lubrication of the saw chain
during cutting operations is essential to minimize friction
with the guide bar!
1. Position the unit in a way that the bar and chain oil
tank cap faces upwards.
2. Open the cap and check the oil level. If the oil level
is more than 0.39-0.79in.( 10-20 mm ) blow the
screw thread, please fill the tank.
3. Do not overfill and leave approx. 0.20in.(5 mm)
space between the top of the oil and the inside
edge of the tank to allow for expansion(Fig. 4).
4. Tighten the cap firmly.
Note: It is recommended that using bar and chain oil.
Fig. 4
13