General Power Tool Safety Warnings; Work Area Safety - Parkside PDSSA 20-Li A1 Traducción Del Manual De Instrucciones Original

Use only the following high-speed battery
charger to charge the cordless tool:
PLG 20 A1*
INPUT:
Rated voltage:
Rated power consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Protection class:
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level
of the tool is typically:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Tightening screws and nuts of maximum
permissible size:
a = 8,65 m/s 2
h
Uncertainty K = 1.5 m/s
Wear hearing protection!
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
PDSSA 20-Li A1
230–240 V ~ , 50 Hz
(AC)
65 W
T3.15A
3.15 A
21.5 V (DC)
2.4 A
approx. 60 min
II / (double insulation)
L = 91,6 dB (A)
PA
K = 3 dB
PA
L = 102,6 dB (A)
WA
K = 3 dB
WA
2
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g. times
when the power tool is switched off and times
where the power tool is switched on but
running without load).
General Power
Tool Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ IE│
15■