Concealed Duct High Static Pressure
3
WIRED REMOTE CONTROLLER
This remote controller can control the operation of up to 8 indoor units.
Display section
In the display illustration below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When turning on the leak breaker at the first time,
of the remote controller.
• While this icon is flashing, the model is being automatically confirmed.
Wait till
icon has disappeared to use the remote controller.
1
2
5
6
7
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or a error
occurs.
3
SETTING display
Displayed during setup of the timer or other settings.
4
TEST run display
Displayed during a test run.
5
Timer display
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
flashes on the display part
12
3
4
8
7
Filter display
Reminder to clean the air filter.
8
Fan speed display
Fan speed is not adjustable.
It is fixed to High.
9
Set temperature display
The selected set temperature is displayed.
10
Power saving mode display
Limits compressor speed (capacity) to save energy.
– 8 –
Owner's Manual
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SAVE
VENT
FILTER
RESET
TEST
SET
CL
SWING/FIX
UNIT LOUVER
11
10
9
13
14
15
(HIGH)
Display
section
Operation
section
EN
8-EN