Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Draw end with 3-input cube and 8-input plug connection to right rear lights:
a) Disconnect 8-input joint from right rear lights and connect to suitable joint in electric bundle,
b) Connect the remaining joint of electric bundle to right rear lights.
8.
Draw remaining end of bundle with plug connection by the side bundle of the vehicle to left rear lights:
a) Disconnect 8-input joint from left rear lights and connect with suitable joint in electric bundle,
b) Connect remaining joint of electric bundle to left rear lights.
9.
Locate 10-input joint behind left side screen in boot.
Additionally in vehicles with light system control, connect single-lead bunch with electronic module of the trailer
- use 10-input connection in bunch.
This joint is not used in vehicles with light system control and bridge connection should not be disconnected.
Additional control set of electric installation
10.
Trailer power supply:
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow, white/brown and white/brown cables) is
provided for expanded socket functions. Put this part of cable set behind the trim. To expand socket functions it is
necessary to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth" part no. 015-069
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
art. no. 014-189
part no. 014-169
Publicidad
