Publicidad
Idiomas disponibles
Idiomas disponibles
Operational condition
• Before putting into operation, check power supply cord (2) and connector as well as extension cable for electrical
and mechanical damage.
• Check the nozzle's basic setting (Detail A).
• Hook the additional weight (23) onto the ground plate (Detail B).
• Mount the guide bar bottom (24) with Screw lever (26).
• Move the guide bar bottom (24) into the required position using the screw lever (26)
and the guide bar top (27) using the clamping lever (25).
• Hook the power supply cord (2) into the cord bracket (12) (Detail C).
• Automatic start-up system
If required, the automatic start-up system is set, depending on the position of the nozzles
with the switch pin (21) and set screw (22).
Connect tool to rated voltage.
230
FI
400
Rated voltage stated on the device must correspond to line/mains voltage.
• Switch the device on with the main switch (17). The hot-air blower (3) starts automatically.
• Deactivate the accidental start-up protection by pressing button
• Important: undervoltage
If the maximum temperature is not reached, reduce the volume of air with the manual air slide (14).
Detail A
a
4
a = 40 – 50 mm (1.6 – 2.0 inch)
b = 1 – 2 mm (0.04 – 0.08 inch)
Operating Instructions
Perform a test welding according to the welding instructions of the material manufacturer and the
national standards or guidelines. Check the test welding. Adapt the welding temperature (welding
parameters, page 13) as required.
Positioning device
• Raise the hot-air blower (3) with the swivel lever (19) as high as it will go. The ball press screw of the
transportation safety device for the hot-air blower (16) must lock in place.
• Position the welding machine on the overlap of the material to be welded. To do this, the external edge of the
drive/pressure roller (6) and the guide roller (20) must fit with the overlap edge of the welding material.
Detail B
b
6
on the keyboard (18).
M
Detail C
12
25
27
24
26
15
Publicidad
