Heath Zenith DualBrite 4115 Instrucciones De Instalación página 2

MODE SWITCHING SUMMARY
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for 1
on. After the calibration time the control will
be in the AUTO mode.
DUALBRITE
®
Light comes on half bright for selected time
after dusk (Off, 3 hr., 6 hr., until dawn). Selecting
OFF disables this feature. The motion sensing
features will continue to work as described in this
manual. If motion is sensed, the light turns on
full bright for the ON-TIME (1, 5, or 10 minutes)
then returns to dim mode.
INSTALLATION
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers
• Safety glasses
• Silicone caulk
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker or fuse.
ON-TIME Switch at 1,
5, or 10 minutes
Flip light switch
off for one second
then back on*
/ minutes, then back
1
2
DIMMER CONTROL
• Wire strippers/cutters
• Light bulb
1. Remove two nuts.
SENS
MIN MAX
4. Set sensitivity control on back
Wire Path
5. Attach mounting plate
to junction box.
This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to fit
the majority of junction box applications.
However, if the slots on the mounting plate do
not line up with the junction box screw holes:
1. Remove the fixture mounting screws from
the mounting plate. Note: Do not remove
the ground screw.
2. Attach ground wire "pigtail" to ground screw
on mounting plate (See Recommended
Grounding Method for additional informa-
tion).
3. Flip the mounting plate over.
2
2. Remove
Mounting
Plate.
3. Tighten screws
finger tight.
of fixture to mid-position.
Ground Screw
206872-01