Operating Instructions - Flex CS 60 WET Manual De Instrucciones

Operating instructions

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power tool
Unpack power tool and accessories
and check that no parts are missing
or damaged.
Connection to the power supply –
power tools with PRCD switch
WARNING!
This electric power tool may be operated
with the supplied PRCD switch only.
Before using the power tool, always check
that the PRCD switch is functioning correctly.
Before using the power tool, always check
the PRCD switch
Insert the mains plug into the socket.

Press "RESET" button (1.).

The red indicator light must come on.
Press "TEST" button (2.). The PRCD

switch must switch off and the indicator
light go out.
When the "RESET" button is pressed

again, it must be possible to switch
on the machine.
22
WARNING!
If the PRCD switch repeatedly switches
off when the machine is switched on or
if the PRCD switch does not trip,
immediately disconnect the machine from
the power supply. Do not continue using the
machine. Have the PRCD switch replaced
by appro-priately qualified technicians or
customer service only.
Connection to the isolating
transformer – power tools with
contour plug
WARNING!
In accordance with VDE 0100 hand-
operated machines used for wet working
must be operated via a suitable isolating
transformer in accordance with EN 61558.
CAUTION!
Voltage specifications on the rating plate of
the electric power tool must correspond with
the output voltage of the isolating
transformer used.
The electric power tool features a contour plug
in accordance with IEC 60309-2 with an earth
contact in the 12 o'clock position which allows
the connection to an isolating transformer with
corresponding socket.
The FLEX isolating transformer TT 2602/
TT 2000 complies with the stated regulations.
WARNING!
Have the contour plug on the wet grinder
replaced by appropriately qualified
technicians or customer service only.
CS 60 WET