CS 60 WET
Water connection
NOTE
If there is no connection to the water supply
mains, it is recommended to use the mobile
water pressure tank WD 10 (capacity 10 litres,
4 m pressure hose, order no. 251.622).
Attach ½" water hose to standard
self-locking quick coupling.
Do not open shut-off valve until at the
place of use and the cutting-off wheel is
rotating.
NOTE
When cutting, adjust the water supply
as required. Re-adjust while cutting.
When removing the hose, ensure that
no water runs into the machine.
Attach or change diamond-tipped
cutting-off wheel
Pull out the mains plug.
Press and hold down the spindle lock.
Loosen clamping screw anti-clockwise
using enclosed Allen key.
Unscrew clamping screw (1) and remove
front clamping flange (2).
Remove cutting-off wheel (3).
CAUTION!
Note installation position of back (4) and
–
front clamping flange (2).
The cutting direction of the teeth (direc-
–
tion of arrow on the cutting-off wheel)
and direction of rotation arrow on the
housing must agree.
Insert cutting-off wheel in the correct
position. Attach the front clamping
flange (2) with the flange on the outside
and manually tighten the locking
screw (1) in a clockwise direction.
Press and hold down the spindle lock.
Tighten clamping screw (1) with Allen
key.
23