Battery Charging; Starting Operation - Würth 5700 407 Serie Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-2978-001.book Page 17 Monday, October 10, 2016 2:00 PM

Battery Charging

Note: The battery supplied is partially charged. To ensure
full capacity of the battery, completely charge the battery in
the battery charger before using your power tool for the first
time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
The lithium-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
 Do not continue to press the On/Off switch
after the machine has been automatically
switched off. The battery can be damaged.
Removing the Battery
The battery 6 is equipped with two locking levels that should
prevent the battery from falling out when pushing the battery
unlocking button 7 unintentionally. As long as the battery is
inserted in the power tool, it is held in position by means of a
spring.
To remove the battery 6, press the unlocking button 7 and pull
out the battery toward the front. Do not exert any force.
Changing the Tool (see figure A)
 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as dur-
ing transport and storage, remove the battery
from the power tool. There is danger of injury when
unintentionally actuating the On/Off switch.
Open the keyless chuck 2 by turning in rotation direction ,
until the tool can be inserted. Insert the tool.
Firmly tighten the collar of the keyless chuck 2 by hand in rota-
tion direction . This automatically locks the drill chuck.
Dust/Chip Extraction
Dust from materials such as lead-containing coat-
ings, some wood types, minerals and metal can
be harmful to one's health and cause allergic
reactions, lead to respiratory infections and/or
cancer. Materials containing asbestos may only be worked
by specialists.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the mate-
rials to be worked.
 Prevent dust accumulation at the workplace.
Dust can easily ignite.

Starting Operation

Inserting the Battery
Note: Use of batteries not suitable for the machine can lead
to malfunctions of or cause damage to the power tool.
Set the rotational direction switch 11 to the centre position in
order to avoid unintentional starting. Insert the charged bat-
tery 6 into the handle so that it can be felt to engage and
faces flush against the handle.
Reversing the Rotational Direction
(see figure B)
The rotational direction switch 11 is used to reverse the rota-
tional direction of the machine. However, this is not possible
with the On/Off switch 12 actuated.
Rotate clockwise: Move the rotational direction
switch 11 on both sides up to the stop into position
Rotate anticlockwise: Move the rotational direction
switch 11 on both sides up to the stop into position
Setting the Operating Mode
Drilling
Set the torque selector setting ring 3 to the
required torque.
Screwdriving
Set the torque selector setting ring 3 to the "screw-
driving" symbol.
.
.
17